4. DISASSEMBLING AND SERVICING
HIGH VOLTAGE IGNITION
LINE (Check The Insulator For
Damage, If Damaged, Please
Replace It)
③Ignition coil
a) Remove the fuel tank,
air
cleaner,
carburetor and recoil starter assy.
b) Measure the clearance between the
ignition coil and flywheel with the
feeler.
c) Adjust the clearance of the ignition and
flywheel.
d) Adjusting method: Loosen the bolt and move
the ignition coil up and down for adjusting
the clearance, then, screw down the bolt.
To Next Page
Loading...