Cobra Y173V - Page 62

4. DISASSEMBLING AND SERVICING
⑥Timing gear
a）Check timing gear for engagement clearance with aligning two side mark on the gear.
ALIGNMENT MARK
CAMSHAFT GEAR
CAMSHAFT GEAR
Bolt（M8×50）
Oil Seal（25×40×7）
Crankcase Cover
GASKET (DON’T
REUSE IT)
GASKET （ 25.4
×34×1）
GOVERNOR
WASHER
（6.5×12×1）
IN INNER SIDE)
FIX WITH PIN
AFTER SSEMBLING
GOVERNOR.
OIL SEAL
（6×11×4）