Coca-Cola freestyle Flex - Cleaning Nozzle, Injector Ring and Ice Chute; Cleaning Ice bin

© 2023 The Coca-Cola Company | Condential information of The Coca-Cola Company | Coca-Cola Freestyle® Flex User Guide | V7 230309 © 2023 The Coca-Cola Company | Condential information of The Coca-Cola Company | Coca-Cola Freestyle® Flex User Guide | V7 230309
COCA-COLA FREESTYLE
®
FLEX COCA-COLA FREESTYLE
®
FLEX
23
22
Cleaning nozzle and injector ring
1
Using a clean
cloth, twist
the nozzle
counter
clockwise and
pull down to
remove.
2
Scrub nozzle with blunt end of
nozzle brush and soap.
Rinse with warm water.
Allow to air dry.
3
Submerge
nozzle in
sanitizer for two
minutes.
Agitate to
remove air
pockets.
Cleaning nozzle, injector ring and ice chute
| MAINTENANCE | MAINTENANCE
4
Scrub ring area including holes with
pointed end of nozzle brush dipped
in sanitizer.
5
Wipe ring with clean cloth and
sanitizer until it comes away clean.
Wait two minutes.
Repeat scrubbing and wiping ring
with clean sanitizer.
6
Re-insert nozzle
by pushing upward
and rotating
clockwise.
Pour remaining
sanitizer down the
dispenser drain.
Allow to air dry.
Scrub inner
injector rings with
wire-handled brush
dipped in sanitizer.
2
Cleaning ice bin
| MAINTENANCE
1
Remove all ice by using
the on screen ice button
(if a top-mounted ice
maker is installed,
follow manufacturer's
recommendation for
cleaning).
2

dispenser. Remove the
ice bin lid and pour warm
water slowly into the bin
to melt the remaining ice.
4
Spray approved sanitizer
solution on all internal
surfaces and lid again,
allow draining and air
dry. Return to normal
operation.
NOTE: For complete
disassembly instructions,
contact your Coke
representative.
3
Spray approved sanitizer
solution (Kay-5) onto all
internal surfaces of ice
bin and both sides of ice
bin lid. Wipe or scrub
areas within reach inside
the bin with either a clean
cloth or an ice bin brush
(small parts #149322).
Cleaning ice chute
1

power button.
2
Using the ice
chute brush
and
approved
sanitizer
solution,
clean the
inside of the
chute.
3
Wait two minutes to allow to air dry,
then repeat step 2 with fresh
sanitizer solution.
4
Wipe the outside of the ice chute tip
using a clean cloth and fresh
sanitizer solution.
Allow to air dry before resuming
normal operation.