2
Using a cloth to protect fingers
twist nozzle counter-clockwise,
and then pull down to remove.
1
Locate the nozzle.
8
Allow the nozzle to air
dry. Use a cloth to put
the nozzle back in place,
and then turn clockwise
to lock.
3
Place the nozzle in a
clean sink and rinse with
warm, drinkable water.
4
Place the nozzle in
the prepared
sanitizer solution.
7
Use a clean brush or cloth and the
rest of the sanitizer solution to wipe
underneath the valve where the
nozzle connects (A), as well as the
chrome cover (B) of the nozzle area.
9
Conduct a taste test by following
the steps outlined on the “Conduct
a Taste Test” page 8.
CAUTION:
DO NOT soak
nozzle overnight.
WARM
6
Soak the nozzle in
the sanitizer solution
for 15 minutes.
15
5
Scrub the nozzle using
the brush shown.
?
If drink taste is
satisfactory, the
nozzle cleaning
task is complete.
If an off-taste is
noted, refer to
“Troubleshooting”on
pages 25-26 of this
guide for assistance.
Troubleshooting
To Next Page
Loading...
