Cocraft LS5T - General Safety Instructions

3
ENGLISH
Warning: None of thesafety devices on theproduct must be modified in anyway.
Wear protective gloves.
Wear non-slip safetyshoes.
Switch off and unplug theproduct whenever it is not in use and before it is cleaned or serviced.
Warning: Always work alone with thelog splitter. Twopeople must not operate thelog
splitter at thesametime.
Warning: Never use theproduct in therain or in wet conditions.
General safety instructions
1. Keeptheworking area tidy. Cluttered surfaces and benches invite accidents.
2. Donot use themachine in dangerous environments. Themachine should not be used on moist or wet
surfaces or in rain. Makesure that thework area is well lit. Whenworking in dusty atmospheres, make
sure that theair is adequately circulated. Donot operate power tools in explosive atmospheres, such as in
thepresence of flammable liquids, gases ordust.
3. Avoidelectric shocks. Avoidbody contact with earthed or grounded surfaces such as pipes, radiators,
ranges and refrigerators when using powertools.
4. Keepchildren and bystanders away. Keepchildren and visitors at asafe distance from electrical machi-
nery/tools and electric cables in theworkplace.
5. Storepower tools out of thereach of children. Whennot in use, power tools should be stored locked
away in asafe place, away from children.
6. Donot force themachine. Thecorrect feed rate makes thework better andsafer.
7. Usethecorrect tool for thejob. Donot force atool to perform atask that it was not designed for.
8. Wearsuitable attire. Donot wear any loose-fitting clothing, gloves, necklaces, bracelets or other jewellery
that can get caught in moving parts. Non-slip footwear is recommended. Wearahairnet or similar if you have
longhair.
9. Alwayswear safety glasses. Normalglasses are not tough enough to withstand impacts. Useadust mask
or dust filter when working in dusty environments.
10. Connect dust extraction equipment. Ifthemachine is equipped with dust extraction equipment, ensure
that it is connected and used properly. Makesure to empty thedust bag regularly.
11. Donot abuse themains lead. Donot carry themachine by its mains lead. Donot yank themains lead to
turn thepower off, pull theplug out instead. Makesure that themains lead does not come into contact with
heat, oil, or sharpedges.
12. Securetheworkpiece firmly. Wherepossible, use clamps or avice. Youcan then operate thetool using
two hands. Thisis much safer than holding theworkpiece in onehand.
13. Donot overreach. Makesure that you stand steady and balanced alltimes.
14. Lookafter your tools. Keepblades sharp and clean for thebest and safest performance. Followtheinstruction
manual’s recommendations regarding lubrication and replacement of accessories. Inspect themains lead regularly.
Ifit is damaged it should be replaced by aqualified service technician. Inspect all leads and cables regularly to check
for any damage. Makesure that themachine’s handles and controls are clean, dry and free from oil and grease.
15. Turnthepower off. Pullout theplug and push in theemergency stop button before servicing or changing
any blades, drill bits, cutters or sanding discs.