1.) For all Euro Tone Programming, refererence Chart 1 on Page 13.
2.) A.) Pressing the Secondary (SEC) button once will light up the button. This is enabling that
“multiplier”. If the Secondary (SEC) button is pressed again, the button backlighting will
turn OFF and disable that “multiplier”.
B.) Pressing the Repeat (▲) button once will light up the button. This is enabling that
“multiplier”. If the Repeat (▲) button is pressed again, the button backlighting will turn OFF
and disable that “multiplier”.
C.) Pressing Secondary (SEC) once and Repeat (▲) once will light up both buttons. This is
enabling that ”multiplier”. If both buttons are pressed again, their backlighting will turn off
and disable that “multiplier”.
D.) After the multiplier(s) is chosen, use the ◄ and ► to navigate the lights in the yellow
bargraph area of the control head to choose the tone that is desired. After tone selected,
pressing Alt will save the selection & continue to next step in programming.
ALT Will advance the programming mode to next step.
PROGRAMMING STEP #3:
SELECTION OF DIFFERENT YELP SIREN TONES:
the following keys will be illuminated:
WAIL/YELP (will be ashing) Indicating Step #3 in Yellow bargraph will
programming mode. light according to its
current program
tone selected.
(Use Up & Down
keys to select one
of the choices. Bar
graph will indicate
choice of selection)
1.) For all Euro Tone Programming, refererence Chart 1 on Page 13.
2.) A.) Pressing the Secondary (SEC) button once will light up the button. This is enabling that
“multiplier”. If the Secondary (SEC) button is pressed again, the button backlighting will
turn OFF and disable that “multiplier”.
B.) Pressing the Repeat (▲) button once will light up the button. This is enabling that
“multiplier”. If the Repeat (▲) button is pressed again, the button backlighting will turn OFF
and disable that “multiplier”.
C.) Pressing Secondary (SEC) once and Repeat (▲) once will light up both buttons. This is
enabling that ”multiplier”. If both buttons are pressed again, their backlighting will turn off
and disable that “multiplier”.
D.) After the multiplier(s) is chosen, use the ◄ and ► to navigate the lights in the yellow
bargraph area of the control head to choose the tone that is desired. After tone selected,
pressing Alt will save the selection & continue to next step in programming.
ALT Will advance the programming mode to next step.
T56095 Rev. A Page 15 of 22
To Next Page
Loading...
Need help?
General
