4
FIGURE 3
FIGURE 2
Attaching the pivot arm brackets
Attach the outer brackets that are supplied noting the difference between passenger and driver side
brackets. Position the bracket on the passenger sun visor's pivot arm as shown in Figure 4. Rotate the
pivot arm on the passenger sun visor and verify the orientation of the bracket as shown in Figure 5. Note
that the thicker portion of the pivot arm hinge aligns to the upper inside hole. Attach the first two torx
screws as shown in Figure 5 and Figure 6. Next, move the sun visor over in order to gain access to install
the final screw into the lower position as shown in Figure 7. Repeat this operation for the driver sun visor
and outer bracket.
Attach brackets to sun visor retaining clips
In order to remove the sun visor retaining clip, unscrew the one torx screw holding it in place. Place the
inner bracket on the retaining clip as shown in Figure 2. Attach to the inner bracket and retaining clip to the
headliner as illustrated in Figure 3. Do not tighten these screws at this time.
Inner mounting bracket modified
to fit all 2005 Crown Victorias
To Next Page
Loading...
