8
FIGURE 10
Mounting the SuperVisor™ (continued)
The inside bracket should line up with the holes in the SuperVisor's lower chassis. Using the supplied 1/4"-
20 bolts and internal tooth lock washers, loosely install them as shown in Figure 10.
Next, if necessary, slightly loosen the three pivot arm bracket and sun visor retaining clip torx screws in
order to align the pivot arm bracket's hole with the mating chassis hole on the end of the SuperVisor.
Finally, thread the supplied bolts and the internal tooth lock washers through the pivot arm bracket's hole
into the hole on the end of the chassis, shown in Figure 11. Tighten all pivot arm and sun visor retaining
clip torx screws.Using a tape measure and a level, center the SuperVisor from side to side and locate a
position on the headliner where the SuperVisor is level. Finally, tighten both bolts securely. Do not
overtighten. Repeat these steps for the passenger side.
Caution: The bracket fasteners make excellent hard mounting points for
radar guns and video cameras etc. Drilling into the housing of the light
bar could damage wiring or other internal components.
FIGURE 11
To Next Page
Loading...
