Code 3 SuperVisor - Installation and Mounting; Attach Brackets to Sun Visor Retaining Clips

FIGURE 3
FIGURE 2
Attach brackets to sun visor retaining clips
In order to remove the sun visor retaining clip, unscrew the one torx screw holding it in place. Place the inner bracket on the retaining
clip as shown in Figure 2. Attach to the inner bracket and retaining clip to the headliner as illustrated in Figure 3. Do not tighten these
screws at this time.
Note: Some time between January 1st and January 10th of 2005, Ford made changes to the 2005 model of
the Crown Vic. To confirm that you have a 2005 vehicle with the changes, measure the distance between the mounting screws
fastening the two inner sun visor clips, if the distance between the clips measures 11 1/4" the vehicle was built before the
change, if the distance measures 13 1/4" it is the new 2005 version and has the change
. The inner mounting brackets shown in
Figure 3 are for vehicles built before the change and will not work for the newer vehicles. The inner mounting brackets shown
in Figure 3A will work in both the new and old vehicles. The basic installation is the same except when mounting the
SuperVisor to the inner brackets install the 1/4-20 x1/2" mounting screws into the slot in the inner mounting bracket that is
nearest the mating hole in the SuperVisor's Outer panel see Figure 3B.
FIGURE 3A
FIGURE 3B