20 ca6555E Owners revA
Programming Replacment Remote Controls
Remote Transmitter Programming
1. Turn the ignition ON.
2. Press and hold the valet/override button located on the antenna.
3. Within 10 seconds the system will chirp (3) three times.
4. Press 1 button of each transmitter you wish to program.
5. The system will respond with 1 chirp for each accepted transmitter.
6. Turn the ignition OFF to exit programming.
NOTES:
• The system will exit transmitter programming after 15 seconds of inactivity.
• This system has 1 button programming which simultaneously programs all channels
of the system.
• The system will hold up to 4 transmitters in memory, programming a 5th transmitter
will erase the oldest transmitter in memory.
• Pressing the valet/override button at anytime during transmitter programming will
advance to the feature bank programming.
Transmitter programming for 2 Car Mode - LCD remote only:
1. Enter the transmitter into 2 Car Mode. (Refer to transmitter operation in the
owners manual for 2 car operation)
2. Follow the steps above for transmitter programming.
NOTE: 2 car mode requires an additional 2-way LCD system installed in a second
vehicle.
To Next Page
Loading...
