How to fix volume too low or loud on Code Blue Security System amp?
To address low or loud volume on your Code Blue Security System's amplifier, first adjust the volume within the IA4100/IP5000 programming. For IA4100, use in-call commands 28 to increase and 29 to decrease volume. For IP5000, modify the Public Address Gain under hardware settings. Additionally, manually adjust the input gain on the amplifier using the input gain dial.
What to do if there is no power to Code Blue Security System unit?
If your Code Blue Security System unit has no power, check the following: * For CB 1 or 5 units, ensure 120V AC is reaching the transformer. * For CB 2-e units, confirm either Hi-Voltage to the power brick or 24V AC to the unit if it's a low voltage setup. * For WM-180° units, verify 24V AC is supplied to the unit.
What to do if strobes are not working on Code Blue Security System?
To troubleshoot non-working strobes on your Code Blue Security System, check the 5 amp slow blow inline fuse located between the transformer and the 5-finger manifold. Also, inspect the power connector at the 5-finger manifold and the red/black power wire from the strobe. To test the strobe's functionality, short the yellow relay wires from the strobe. If the strobe flashes, verify the programming in the IA4100/IP5000 speakerphone.
How to troubleshoot PAS not working on Code Blue Security System?
If the PAS (Public Address System) is not working on your Code Blue Security System, remove the control cable from the amplifier to keep the amp on at all times, and then try a new test call. Also, test the power from the transformer to the amp.
General| Brand | Code Blue |
|---|---|
| Model | CB 1-e |
| Category | Intercom System |
| Language | English |
To Next Page
