The spindle must project from the inside face of the door by at least 8mm (⁄") so as to engage the
handle. The spindle may have been cut too short during installation. Call the helpline to obtain a
longer spindle.
7. The inside lever handle does not return to the upright position after operating.
The lever return spring is broken. Replacement spring required.
8. The latch does not engage and so the door remains unlocked after use.
The latch is not entering the strike.
Your door or frame may have warped since the lock was installed. Check that the latchbolt is lined
up with the strike aperture and adjust the position of the strike as necessary. Make sure the
deadlocking plunger cannot enter the strike aperture alongside the latchbolt when the door is
closed.
CC-CL100/200-v1:0218
© 2018 Codelocks Ltd. All rights reserved.
Keywords: Lock Locks Code CodeLock CodeLocks Program Programming Instruction Instruct Help
Support Troubleshoot Troubleshooting Sequence Sequences Install Installation Parameters Settings
Setting Parameter Setting Set up Mechanical CL CL100 CL200 100 200
To Previous Page
Loading...
