Document Version: 0.2 Status: Draft
Page 9 of 9
1. Via the K3 App, open the Info screen of the lock to be updated
2. Select Firmware Version
3. The Firmware Upgrade page will open. To view the details about the upgrade, click Details.
Select Download Firmware to start the download process
4. Once the Firmware has downloaded, an Upload Firmware to Lock button will display. Click
this button to continue the process
5. On the lock, enter the pairing command:
#Master Code • 00 • 1 ••
6. The upload progress will display in the App
7. Once the firmware has uploaded to the lock, wait for the keypad to stop flashing red. Once
you receive an Upgrade Successful message via the App and the keypad stops flashing red,
the upgrade will be complete.
During upload process, keypad will flash red. This process may take several minutes. You will receive
a message in the App when the upload process has completed. The lock keypad will continue to flash
red while the new firmware is applied. Once the keypad has stopped flashing, the process is
complete.
To Previous Page
Loading...
