Check that the lever handles are correctly orientated
for the hand of door. To change the hand of a lever
handle see Section 1A, Step 3 (CL500/CL505).
N/A for CL500 KEY models.
Fix the two plates together using the socket head bolts,
starting with the top fixing. Ensure that the two plates
are truly vertical and then tighten the bolts using the
‘T’ shaped Allen key. Do not use excessive force.
Apply the front and back plates, with the neoprene seals
in position, against the door, over the protruding ends
of the spindle.
If not using the fixed length bolts, cut two of the
socket head bolts to the required length for your door.
Approximate overall length should be door thickness
plus 25mm (1”) to allow about 10mm (
3
/
8
”) of threaded
bolt to enter the outside plate.
STEP 8
STEP 9
STEP 11
STEP 10
STEP 7
For door hung on RIGHT fit silver spindle
on code side.
For door hung on LEFT fit coloured spindle
on code side.
Fit the butterfly spindle to the inside,
non-code side.
To Next Page
