CODELOCKS CL5000 - CODES AND OPERATION; CODES; OPERATING INSTRUCTIONS

CODES
• ThefactorysetMasterCodeis # 1234.
Thisshouldbechangedimmediatelyafterinstallation(see
Program10).
• TheMasterCodeandoptionalSub-MasterCodealwaysstart
withthe # prefix.ThisputsthelockintoProgrammingMode.
• WhentheMasterorSub-MasterCodeisentered3times
consecutivelywithoutperformingaprogrammingfunction,
apenaltytimeof10secondsisactivated.
• ThelengthoftheMasterCodedeterminesthelengthofthe
UserCodesandtheSub-MasterCode.
• IftheMasterCodeischangedtoanotherofthesamelength
thentheSub-MasterandallUserCodeswillberetained.
• IftheMasterCodeischangedtooneofadifferentlength
thentheSub-MasterandallUserCodeswillbedeleted.
• Codesmaybe4,5or6digitslong.Thelockmemorywill
store989differentUserCodes,eachidentifiedbyaUser
CodeID-001-989.
• Thelockmemorycanstore10differentOneTimeUser
Codes.EachOneTimeUserCodeisidentifiedbyaOne
TimeUserCodeID-990to999.
• IfProgram16isactivated,UserCodescanbetset
individuallyorasagroupusingProgram17toenablethe
locktobeopenedonlyatspecifiedtimes.
• WheninProgrammingModeaProgramCodemustbe
enteredwithin5seconds,otherwisetheRedLEDwillflash
andBEEPandthelockwillreverttonormal.
• Ifaprogrammingmistakeismadewait5seconds,theRed
LEDwillflashandBEEPandthelockwillreverttonormal.
• Anewcodewillberejectedifitisalreadyinthememory.
OPERATING INSTRUCTIONS
TheCL5000ATlockhasa12buttonkeypadincluding
✱and # buttons.
AUDIT TRAIL FUNCTION
TheCL5000AThastheabilitytoprovideaudit
informationoflockactivity;timelockopened,UserCode
usedetc.Onceactivated(Program16)thesamesoftware
allowsforeasyprogrammingoflocksviaaUSBStick
fromaPCtothelockandfromthelockbacktothePC.
Multiplelockscanbeprogrammedinthiswayifrequired.
UNLOCK TIME
Thefactorypre-setUNLOCKtimeis4seconds.Thismay
bechanged–(seeProgram06).
PENALTY TIME
Entering3incorrectcodeswillcausethelocktosuspend
activityforapenaltytimeof10seconds.
KEY OVER-RIDE
Turnthekeyclockwise90ºanddepresstheleverhandle
toopenthedoor.
CODE FREE MODE
UsingtheMasterortheSub-MasterCode,Programs08
and09willputthelockinto,andoutof,CodeFreeMode.
InCodeFreeModebatterypowerisnotbeingused.If
MasterandSub-MasterCodescannotbeissuedforthis
purposeitispossibletousetheKey-in-Levertoputthe
lockintoCodeFreeMode.Thisrequiresthatthecylinder
tailpiecebechangedaccordingtotheinstructionon
pages4and5.
CODESANDOPERATION