CODELOCKS CL5000 - PROGRAMMING: USER AND ACCESS MANAGEMENT; USER CODE PROGRAMMING; ACCESS TIME AND UNLOCK SETTINGS

6
ENTER NEW USER CODE
# MasterCode
•
01
•
UserCodeID(e.g.001)
•

NewCode(e.g.4321)
••
Result:Newcode4321enteredatUserCodeID001.
(
•
whenuserenterscode)
Note: IDpositions990to999arereservedforOne-TimeUserCodes.
SUSPEND USER CODE
# MasterCode
•
02
•
UserCodeID(e.g.001)
••

Result:UserCodeatID001suspended.
(
••
whenuser001enterscode).
RESTORE USER CODE
# MasterCode
•
03
•
UserCodeID(e.g.001)
••
Result: UserCodeatID001restored.
(
•
whenuser001enterscode).
SUSPEND ALL USER CODE
# MasterCode
•
04
••
Result:AllUserCodessuspended.
(
••
whenuserenterscode).
RESTORE ALL USER CODES
# MasterCode
•
05
••
Result:AllUserCodesrestored.
(
•
whenallusersentercode).
CHANGE UNLOCK TIME
# MasterCode
•
06
•
enteropentime(range2-9secs)
••

Result:Aftercodeentrythelockwillunlockforthesettime.
(Factorypre-settimeis4seconds).
ONE-TIME USER CODE
# MasterCode
•
07
•
OneTimeCodeID(e.g.990)
•

One-TimeCode(e.g.5555)
••
Result:Code5555inposition990willworkonceandthenbe
removedfrommemory.
Note: IDPositions990to999arereservedforthis
programfunction,allowingupto10One-TimeUserCodesto
beentered.
* First change the factory Master Code #1234 – see Program 10.
Note:TheMasterCodeandSub-MasterCodeMUSTalwaysstartwith # .AllcodesmustbethesamelengthastheMasterCode.
A
•
or
•
intheKeySequencebelowindicatesLEDillumination.TouseAuditTrailFunctionandprogrammingviaPCProgram16
mustbeactive.
IF ENTERED, A SUB-MASTER CODE CAN BE USED INSTEAD OF THE MASTER CODE FOR ALL PROGRAMS EXCEPT
PROGRAMS 10,12,14,16,17,18 AND 19.
PROGRAM 01 PROGRAM 05
PROGRAM 02
PROGRAM 06
PROGRAM 07
PROGRAM 03
PROGRAM 04
PROGRAMMING