Created by EBCCW 00:06
iii
5815EN-03
1 General safety and design considerations 1
1.1 Introduction 1
2Safety 3
2.1 System information 3
2.2 Important safety conditions 3
3 Maintenance 7
3.1 System maintenance 7
3.2 Maintenance instructions 8
3.3 Introduction to drive units 9
3.4 Slip clutch adjustment 10
3.5 Inspection – drive units 12
3.6 Inspection – conveyor chains 14
3.7 Inspection – slide rails, beams, idlers, bends 18
3.8 Inspection – safety devices 20
3.9 Replacement of worn parts – conveyor chain 21
3.10 Replacement of worn parts – slide rails 22
4 Troubleshooting 27
4.1 Checklist/maintenance schedule 29
5 System dismantling and disposal 31
5.1 Important safety precautions 31
5.2 Dismantling end drive units with suspended
motor 32
5.3 Dismantling end drive units, no slip clutch 34
5.4 Dismantling end drive units, slip clutch 35
5.5 Remove guide rails and guide rail brackets etc.
36
5.6 Remove the conveyor chain. 37
5.7 Dismantling end drive units 38
5.8 Remove slide rails 39
5.9 Dismantle the conveyor extrusions from the
support brackets. 40
5.10 Dismantle the conveyor support system 41
5.11 Recycle 43
To Next Page
Loading...