Coffee Queen Mega Gold A - Electrical connection; Hot plate function

ORIGINAL LINE A
20
Original instructions.
INSTALLATION AND START-UP
Electrical connection
Important:
Connect the plug to a separate earthed wall socket.
110-120V / 220-230V 50-60Hz, 10 Amp.
A-2, THERMOS A, MEGA GOLD A
DA-4
The brewer is not reconnectable and may only be installed to the electric
supply network with a voltage that is stated on the brewer and shall be carried
out by an authorized electrician.
Recommended: install a line circuit breaker and a earth fault breaker to the
machine.
WARNING!
Connection to a separate 2 phase only
- Brewer should be connected to 110V / 220V with neutral and ground.
- Use 10 Amp fuses.
Important:
Electrical installations must be done by a certicated electrician.
Hot plate function
Turn on left power switch:
I
for lower hot plate,
and right power switch:
II
for upper hot plate.
Ensure that the lamps turn on and that the hot plates get
warm.
Turn off power switches
I
and
II
when not in use.
II
Upper hot plate
I
II
I
Lower hot plate