Cointra TL plus Series User Manual

10
- Do not tamper with the excess pressure safety device,
only move it from time to time to ensure that it is not
stuck and eliminate any dirt or grease that may have
been deposited on it; the device intake tube must be fit-
ted with a safety device that complies with the relevant
standard, calibrated to a maximum pressure of 0.8 MPa,
to include at least: a tap, retention valve, safety valve
and hydraulic load cut-off.
- It is normal for water to drip from the excess pressure
safety device and the EN 1487 safety device when the
unit is heating up. For this reason, a drain must be fitted
that is in the open air, with a pipe continuously tilted
downwards, in an area that is not subjected to sub-zero
temperatures.

Cointra TL plus Series Specifications

General

Installation	Wall-mounted
Ignition	Electronic ignition
Gas Type	Natural gas / LPG
Energy Efficiency	A
Safety Features	Flame failure device, Overheat protection
Dimensions	Varies depending on model (check specific model datasheet)
Weight	Varies depending on model (check specific model datasheet)