COLBOR CL220R - Installation of light; Install the soft light umbrella; Power Supply; Power cord adapter fixation

Rotate the lamp holder screw until the inner wall is not shielded and put
the product on the top of the lamp holder to tighten the bracket screw for
xation. Adjust the lamp body irradiation angle and tighten the lamp holder
angle grip.
3. Installation of light
Screw out, the inner
wall of the bracket
without any shelter
Halfway the
screw out
The screw is
not out
at all
Screw out, the inner wall
of the soft light cover
without shelter
The screw is not out
at all
Insert the handle of the soft light umbrella into the umbrella hole and tighten
the screw to lock.
4. Install the soft light umbrella
(1) Power cord adapter fixation
Pass the attached wire rope through the snap
ring of the power adapter and hang it on the
stand.
5. Power Supply
(3) Power cord storage
When pulling out the power cord of
the lamp body, firstly press the spring
beside the connector to unlock it. Do
not pull out the wire forcefully without
unlocking it.
(2) AC power supply
Connect the power adapter, aim the pin at the
DC power interface of the lamp body, and then
power on after the cable is well-placed.