Cold Jet PR750H - Page 89

PR750H
MECHANICAL MAINTENANCE
Version:
1
Page:
59 of 69
Date:
2020.12.11
29. Procedure for changing oil on hydraulic station on PR750H and PR350H
This section will describe changing oil on hydraulic station on PR750H and PR350H. During this operation it’s
important to activate the emergency stop button.
Remove the oil. Drain out of this ball valve pos. 1. The used oil must be deposited at an approved station for
environmental waste. Clean the hydraulic tank pos. 2 inside by removing the cover plate pos. 3 on the tank
side. Reassemble the hydraulic tank and close the ball valve. Unscrew the air filter (see picture below) and fill
DTE MOBIL FM 46
Cold Jet
Art.Nr.4F0221. Approved for food manufacturing” in the hydraulic tank to level indicator is
under the black/blue max line.
Notice: If there are no demand for oil approved for food manufacturing, this oil can be used instead DTE MOBIL 10 Excel
46
Cold Jet
Art.Nr.4F0220.
Table 4. Recommended oil volume.
Machine
Volumen (liter)
Type of oile
PR750H
260
DTE MOBIL FM 46 or DTE MOBIL 10 Excel 46.
PR350H
220
DTE MOBIL FM 46 or DTE MOBIL 10 Excel 46.
After completion, check that there are no leaks on the hydraulic station.