Coldelite COMPACTA Series - Hygiene Maintenance and Best Practices for Product Contact Parts

COMPACTA
- 41 -
compacta_g - 02_05
With machine off (not working), fill the boiling cylinder or boiler with non-corrosive sanitizing
solution.
Start the beater by pressing the key 571.2 .
After 30 seconds beating press the key 571.1 . Wait for a time necessary to the action
of the sanitizing solution (10-15 minutes). Transfer the sanitizing solution to the freezing
cylinder, then press the key 571.6 to run the beater for 30 seconds, then press the
key 571.1
CAUTION
Too a longer operation of the machine set at "CLEANOUT" and "BEATING" with empty
cylinders or just full of water with sanitizer, causes a quick wear of the beaters.
Wait for a time necessary to the action of the sanitizing solution (10-15 minutes), then fully drain
the solution using levers 5 and 502.
CAUTION
Do not touch sanitized parts with hands, napkins, or else, any longer.
6.8 HYGIENE
Mildew and bacteria rapidly grow in mix fat contents.
To eliminate them, it is necessary to wash and clean all parts in contact with the preduct, as
described above.
Stainless steel and plastic materials, as well as rubber used in the construction of the machines,
and also their particular shapes and designs make cleanout easy, but cannot prevent proliferation
of mildew and bacteria if not properly cleaned.