39
7.0 GENERAL INDICATIONS FOR USE
From the main screen it is possible to start the Modi functions which may differ depending on the setup.
Numerous recipes are included in Modi aimed at adapting the programs to the food actually inserted into the
blast chiller.
In many blast chilling and deep freezing programs it is necessary to select the mode from:
Core probe: the program will manage the transition from one phase to
another reading the temperature of the core probe. The duration is
determined by the achievement of the actual temperature set in the product
core.
The programs are divided into three phases which allow you to vary the
temperature, ventilation and core temperature of each individual phase; at
the end of the cycle, storage at the desired temperature can be activated.
the program will manage the transition from one phase to another after
the time set according to the recipe.
The programs are divided into three phases that allow you to vary the
temperature, ventilation and time of each individual phase; at the end of the
cycle, storage at the desired temperature can be activated.
Vacuum mode: in some programs it is possible to activate the V - Vacuum
mode; in V - Vacuum mode Modi will work as in time mode, adapting
ventilation and duration in order to optimize the use of vacuum-packed food
where the presence of the bag constitutes an obstacle to cooling it.
Once a program has been started, the following data can always be viewed:
Cell temperature in the centre of the display, if the core probe is connected
it is possible to see the core temperature by selecting the temperature area.
If you only want to see the core temperature, simply select the probe icon, an
acoustic signal will confirm that only the core temperature is active, to return
to the chamber temperature press again in the temperature area.
Ventilation: depending on the programs, by selecting the ventilation field,
you can change it or the automatic management symbol will appear, in
which case it will be possible to change the ventilation only from the program
editor
Set cell temperature: depending on the programs, by selecting the Set cell
temperature field you can edit it or the automatic management symbol will
appear, in which case it will be possible to change the setting only from the
program editor.
Remaining time/elapsed time: indicates the time remaining in the time
programs and the time spent in the probe programs or in the manual cycle
: stops the program.
To Next Page
Loading...
Need help?
General
