17
Factory Defaults - deF
This feature is available for all units and is designed to
restore the control to the default factory settings.
To reset to the Factory Defaults follow the instructions
given below:
1. Plug the unit into the appropriate power, but do
not turn it on (displays should be blank, unless
Hot Top Warning System is indicating a hot sur-
face), enter the Service Menu by pressing and
holding the POWER key. After about 3 seconds
a single beep will be heard and you may
remove your finger from the POWER key. The
display will change to OSP.
2. Rotate the center knob until the display reads
dEF. Press either “Heat” or “Stir” key to accept,
and the display will change to no. Rotate the
center knob to change the display to yES and
press either “Heat” or “Stir” key.
3. The unit has now been returned to the factory
default settings. The unit will return to the previ-
ous menu. Select another feature to change, or
press the POWER key again to return to the off
mode.
General Cleaning Instructions
Keep top surface clean. Use a non-abrasive cleaner.
Alkali spills, hydrofluoric acid spills or phosphoric acid
spills may damage top and lead to thermal failure. Unplug
unit and remove spills promptly. Do not immerse unit for
cleaning. Wipe exterior housing with lightly dampened
cloth containing mild soap solution.
SERVICE AND CALIBRATION
To Next Page
Loading...