EasyManuals Logo

Coleman 2302-A User Manual

Coleman 2302-A
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
10
Troubleshooting Guide
Symptom Possible Cause Solution
Hot water warning
Water tank/carrier is running out of water Fill water tank/carrier with water.
Environment temperature is high Turn control knob to a cooler setting.
Temperature sensor defective Contact Coleman Service Center and return the product to Coleman when necessary.
Tilt warning
Heater is tilted more than 30 degrees. Gas & pump will be shut off immediately.
Sensor defective Contact Coleman if under warranty.
Flames out warning
Flames blown out by strong wind / pilot light is
out
Do not use in strong wind condition. Turn off the heater completely and restart the ignition
sequence.
Flame detection module defective Contact Coleman if under warranty.
Low battery warning
Battery voltage lower than 9.8V. Recharge the battery.
Defective battery Contact Coleman if under warranty.
Low water flow warning
Pump is not in correct position Rotate pump so “THIS SIDE UP” is facing upward.
Water tank/carrier out of water Fill water tank/carrier with water.
Pump inlet screen clogged Clean the screen, seen instructions given in maintenance section.
Hose twisted / kinked Straighten hose.
Battery lead disconnected Remove battery cover & reinstall lead.
Pump power cord disconnected Plug cord into power socket on heater.
Low battery Recharge the battery.
Flow rate sensor defective Contact Coleman if under warranty.
Burner will not light
Propane cylinder empty Replace cylinder.
Propane cylinder frosted Replace cylinder and reuse after thawing.
Fuse defective Refer to maintenance section and replace the fuse.
Electronic circuit defective Contact Coleman if under warranty.
Water leakage
Connectors cross-threaded;
Sleeved-connectors were not locked into place
Reconnect the connectors.
Read instructions for connecting sleeved connectors and reconnect the connectors.
Defective seal or break
Replace sealing components (O-rings) or send to Coleman when necessary
Hose turns white or
discolors inside
Calcium buildup Clean heater (refer to section “cleaning instructions” on page 7)
Battery won’t hold a Charge
Defective Battery Contact Coleman if under warranty.
Main power switch is neglected See Helpful Hints section on how to use the main power switch
No display
Battery lead disconnected Remove battery cover & reinstall lead
Fuse defective Refer to maintenance section and replace the fuse.
Electronic circuit defective Contact Coleman if under warranty.
Low battery Recharge the battery.
Main power switch at “OFF” position (for model
2302-A only)
Turn on the main power switch
Technical Characteristics
Pressure: 2.8 kPa
Injector size: 0.026 in (0.66 mm)
Total gas consumption: 21.0 MJ/h
Gas type: Propane LPG
Replacement Parts
Parts List
1. 2000027853 Shower
2. 2000027851 Li-Ion Battery
3. 2000027849 Pump Assembly
4. 2000027850 Adapter – 120V
5. 2000027848 Adapter – 12V
6. 2000027847 Water Carrier
7. 2000027845 Shower Arm
8. 2000027844 Fuse
9. 2000027842 Shower Assembly Carry bag
10. 2000027937 Shower Hose
- Contact Coleman -
www.coleman.com | 1-800-835-3278 | TDD 316-832-8707

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Coleman 2302-A and is the answer not in the manual?

Coleman 2302-A Specifications

General IconGeneral
BrandColeman
Model2302-A
CategoryWater Heater
LanguageEnglish

Related product manuals