Connect Frame to Tent
– Insert one pin into the end of main tent
pole at tent corner. (illus. 3, illus. 4)
– Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole end.
– Repeat for second pole.
– Insert pin into the end of side pole, go to
opposite end of pole and apply pressure
until you arch the pole and can insert
the pin into the pole. (illus. 3, illus. 4)
– Repeat for other side pole.
Eagle Rock
™
9’6”x7’
1
Layout & Positioning
of Tent, Pole Assembly
– Layout and position tent with door facing
desired direction. (illus. 1)
– Unzip door.
– Stake down tent corners only, using the
stake loops. Keep the floor taut.
(Intermediate loops will be staked later.)
– Assemble frame poles by interlocking
shock-corded poles. (four poles)
– Insert the poles into pole sleeves.The
longer black poles should cross forming
an “X” in the middle of tent. The shorter
side gray poles insert into sleeves
running front to back. (illus. 1)
2
When You Are Ready
To Set Up Your Tent
– Select a level campsite clear
of rocks, branches and other
hard or sharp objects.
– Do not set up your tent
under trees.
– For best results in windy
conditions position the end
of tent into the wind.
Part No. 9277F950
Front Door
Side Poles
Assembled
poles
inserted
through
pole
sleeves
Instructions apply to Part Number 9277F957
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9277F953
Part No. 9277F952
illus. 3
Insert pin into pole end
Rainfly
Part No. 9277F951
(2) Main Tent Poles
(2) Side Poles
(2) Rainfly Pole
To Next Page
Need help?
General