8-48 Periodic Maintenance and Adjustment
Specified Fuse:
Main Fuse:
Headlight Fuse:
Ignition Fuse:
Auxiliary DC Jack Fuse:
Signaling System Fuse:
Carburetor Warmer Fuse:
2WD/4WD Fuse
30.0A
15.0A
10.0A
10.0A
10.0A
10.0A
3.0A
4. Turn the key to “ON” and turn on the
electrical circuit in question to check if
the device operates.
5. If the fuse immediately blows again, have
a service center check the electrical
system.
6. Install the battery compartment cover.
7. Close the hood.
Replacing Headlight Bulb
If a headlight bulb burns out, replace it as
follows.
1. Lift the hood up. (See pages 8-6 - 8-7 for
hood opening and closing procedures.)
2. Remove the cover at the rear of the
headlight by pulling it off.
1. Cover at the rear of the headlight
To Next Page
Loading...
