INSTASTART™
Electronic Ignition Stoves
■ Set on sturdy, flat surface. For outdoor
use only.
■ Open burner valve and repeatedly push
igniter button until burner ignites.
(Fig. 12)
■ Repeat for both burners.
Note: If the igniter still fails to light stove,
use match to light burner. If the stove is
wet the igniter may not spark.
Fig. 12
Match Lighting
■ Set on sturdy, flat surface. For outdoor
use only.
■ Hold lighted match near burner and open
burner valve. (Fig. 13)
■ Repeat for both burners.
Fig. 13
English-5
To Turn Off
■ Adjust flame with burner valves.
(Fig. 14). Flame should be blue with a
hint of yellow on tips.
■ Close the burner valves firmly. (Fig. 15)
Fig. 15
To Clean
■ Make sure stove is cool.
■ Move stove away from flame (including
pilot lights) and other ignition sources.
■ Remove propane cylinder from
regulator and replace protective cap on
cylinder. (Fig. 16)
■ Remove regulator from stove. (Fig. 17)
• MAINTENANCE
• Keep stove area clear and free from
combustible materials, gasoline and other
flammable vapors and liquids.
• Do not obstruct the flow of combustion and
ventilation air.
• A good flame should be blue with minimal
yellow tip. Some yellow tips on flames are
acceptable as long as no carbon or soot
deposits appear.
• Wipe clean with soft cloth and mild dish
detergent. Do not use abrasives. (Fig. 18)
Fig. 18
Fig. 17
Fig. 14
Fig. 16
■ Make sure stove and griddle are cool.
■ Wipe clean with soft cloth and mild
dish detergent. Do not use abrasives
on the non-stick griddle surface.
Cleaning the Griddle
* Griddles are only available on certain models.
To Next Page
Loading...
