Coleman Monterey 10 18'x10' User Manual

Connect Frame to Tent
–Insert the pin into the end of the black main
tent pole at the rear of the tent.
(illus. 3, illus. 4)
–Go to opposite end of pole and gradually
apply pressure to the pole forming an arch
until you are able to insert the pin into the
pole end. (works best standing in the door,
with two people) Repeat for second pole.
–Insert the pin on the side into the side pole
end. Go to opposite end of pole and
gradually apply pressure to the pole forming
an arch until you are able to insert the pin
into the pole end. (illus. 3, illus. 4)
Monterey
™
10 18’x10’
1
Layout & Positioning of Tent,
Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent, using the rings on the
stake loops. Keep the floor taut. (illus. 2)
–Assemble frame poles by interlocking
shock-corded poles. (three poles)
–Insert the main tent poles through the two
pole sleeves with black trim. The poles
will cross in center of the tent.(illus. 1)
–Insert gray side pole through the pole
sleeves running parallel to the door.
This will go from side to side.
2
When You Are Ready To Set
Up Your Tent
–Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
Rainfly Poles
Front Door
Black Main Poles
through pole sleeves
Gray Side Pole
through pole sleeves
Instructions apply to Part Number 9230-181
illus. 1
illus. 2
Tent stake
through ring
on stake loop
illus. 4
Tent frame
set-up
Part No. 9230-3121
Part No. 9230-3181
Part No. 9230-3141
(Black) Main Tent
Poles
(Gray) Side Pole
illus.3
Insert pin into pole end
Rainfly Part No. 9230-3161
Side Pole

Coleman Monterey 10 18'x10' Specifications

General

Brand	Coleman
Model	Monterey 10 18'x10'
Category	Tent
Language	English

Summary

Tent Setup Preparation and Layout

Tent Layout and Positioning

Position tent with door facing desired direction, unzip door, and stake floor taut.

Main Pole Assembly and Insertion

Assemble shock-corded poles and insert main tent poles through sleeves.

Side Pole Insertion

Insert gray side pole through sleeves running parallel to the door.

Connecting Tent Frame

Attaching Main Poles to Tent

Insert pins into tent pole ends and gradually apply pressure to form arches.

Attaching Side Pole to Tent

Insert side pole pin and apply pressure to form an arch.

Attaching Tent to Frame and Rainfly

Securing Tent to Frame Clips

Attach frame clips along tent edges to poles and adjust corner stakes.

Rainfly Pole Assembly

Assemble rainfly poles and insert through front and rear pole sleeves.

Draping and Securing Rainfly

Drape rainfly over frame, connect loops to rings, insert pole tips, and secure attachments.

Staking Out Guylines

Attach and stake out guylines for added stability.

Important Usage and Care Information

Condensation Management

Minimize condensation by removing wet items and ensuring ventilation.

Tent Storage and Cleaning

Always dry tent thoroughly and brush off dirt before storing.

Stake Removal

Pull stakes directly; avoid pulling tent fabric or loops.

Pole Storage

Do not leave tent poles telescoped together during storage.