Coleman MOUNTAINEER DOM 9160-808 User Manual

Connect Frame to Tent
–Insert one end of main tent pole end
onto pin of ring and pin system, at tent
corner. (illus. 4)
–Go to opposite end of pole and
gradually apply pressure to the pole
forming an arch until you are able to
insert the pin into the pole.
–Repeat for second pole.
COLEMAN
®
MOUNTAINEER
TM
DOM
1
Layout & Positioning
of Tent, Pole Assembly
–Layout and position tent with door
facing desired direction. (illus. 1)
–Unzip door.
–Stake down tent corners only, using the
stake loops. Keep the floor taut.
(Intermediate loops will be staked later.)
–Assemble Frame Poles by interlocking
shock-corded poles. (four poles)
–Insert the poles into Pole Sleeves.The
longer black poles should cross forming
an “X” in the middle of tent. (illus. 1)
–Fasten Frame Tie on top of tent over
both poles. (illus. 1), (illus. 3)
2
When You Are Ready To Set Up
Your Tent
–Select a level campsite clear of
rocks, branches and other hard or
sharp objects.
–Do not set up your tent under trees.
–For best results in windy conditions,
position the end of tent into the wind.
–See owners manual for more tips.
Rainfly
Pole
Rainfly Part No. 9160-408
Main Tent
Poles
POLE ASSEMBLY PARTS
Assembled
poles
inserted
through
pole
sleeves
Frame Tie
Instructions apply to Part Number 9160-808
illus. 1
illus. 5
Tent frame
set-up
illus. 3
Frame Tie
Part No. 9160-208
Part No. 9160-308
illus. 2 Tent stake
through ring
illus.4
Insert pole tip into
grommet on stake loop

Coleman MOUNTAINEER DOM 9160-808 Specifications

General

Brand	Coleman
Model	MOUNTAINEER DOM 9160-808
Category	Tent
Capacity	6-person
Center Height	6 ft.
Pole Material	Fiberglass
Number of Doors	1
Dimensions	240 x 240 cm
Base Size	240 x 240 cm

Summary

Setting Up Your Tent

Tent Layout and Positioning

Position the tent with the door facing the desired direction and stake down corners.

Frame Pole Assembly and Insertion

Interlock shock-corded poles, insert them into sleeves, and fasten the frame tie.

Connecting Frame to Tent

Insert pole ends into tent corner rings, forming arches and securing them.

Attaching Tent Components

Attaching Tent to Frame

Attach frame clips along tent edges to frame poles and adjust corner stakes.

Attaching Rainfly

Assemble rainfly pole, insert into pockets, drape over frame, and secure.

Important Tent Usage Information

Condensation and Ventilation

Minimize condensation by providing good ventilation and removing wet items.

Tent Storage and Care

Dry tent thoroughly before storage; do not leave poles telescoped.

Flame and Heat Source Warning

Keep all flame and heat sources away from tent fabric; it is treated for flammability.