OpInstructions_En.fm
9
6.3 Dispensing speed
The dispensing speed is set with the potentiometer SPEED in m/min.
Dispensing speeds:
Collamat 2610: 3 to 15 m/min.
7 Maintenance
On the Collamat 2600 the winder clutch and the unwinder must periodically
be serviced. The interval of the service depends on the duty and environment
conditions of the labeller. Usually every 2000 working hours or 500'000 labels
of 100mm feeding length the service must be performed. Then depending on
the status of the labeller it must be figured out to do the service in shorter of
longer intervals. The the following items must be regarded:
The traction roll must be checked for wear. It must have grip. Otherwise it
must be replaced. To check just compare the grip at the location where the
backing paper is transported to the the lateral parts which are not used for
paper transport.
Also the dispensing edge must be checked for wear. If there is a tactual notch
at the backingpaper's location the dispensing edge must be replaced. A wea-
red dispensing edge can lead to breaks of the paperwebs.
For further details refer to the technical handbook. This book can be ordered
at your local Collamat representation.
To Next Page
Loading...
