To Next Page
M
michael02Sep 18, 2025
Why does dancer roll get shaky on Collamat 8600?
- PPaul JeffersonSep 18, 2025
If the dancer roll gets shaky on your Collamat Label Maker, fix the screw (use perhaps Locktite), because the shaft screw may be loose.
Why does dancer roll get shaky on Collamat 8600?
If the dancer roll gets shaky on your Collamat Label Maker, fix the screw (use perhaps Locktite), because the shaft screw may be loose.
What to do if motor is dead but display is illuminated in Collamat 8600?
If the motor is dead, the display is illuminated, and the motor driver seems to be okay on your Collamat Label Maker, check the following: * Ensure the motor connector is properly plugged in. * Reconnect the wires between the motor driver, the mains filter board, and the motor connector, if they are not okay. * Replace the mains filter board if the filter components are broken. * Rewire the motor wires properly if they are not connected properly inside the motor.
What to do if motor is dead and display is not illuminated in Collamat 8600 Label Maker?
If the motor is dead and the display is not illuminated on your Collamat Label Maker, check the following: * Ensure the main is connected to the transformer. * Check the main fuse. * Check the internal transformer wiring.
Why do labels form wrinkles with Collamat Label Maker?
If labels form wrinkles when using the Collamat Label Maker, consider the following: * Increase the labeling speed if it is too slow. * Realign the labeler if it is misaligned to the product transport.
Why does dancer bearing get shaky on Collamat 8600?
If the dancer bearing gets shaky on your Collamat Label Maker, replace the module rail and dancer axle, because the module rail may be worn out by the dancer axle.
Why does flange of fixed disk break on Collamat 8600 Label Maker?
If the flange of the fixed disk breaks on your Collamat Label Maker, replace the flange against new series flange, because there may be a material defect or wrong type of aluminum.
Why does adapter tilt down while labeling with Collamat Label Maker?
If the adapter tilts down while labeling with the Collamat Label Maker, thread the paper web correctly between the adapter roll pair, because the backing paper may not be threaded between the adapter roll pair.
Why does Collamat Label Maker monitor frequently reset?
If the monitor frequently resets on your Collamat Label Maker: * Clear all programs using the password 4147 during the power-on procedure due to a software error. * Check the environment and wiring. All cables must be shielded in this case due to electromagnetic interference (EMI).
How to increase speed of Collamat Label Maker?
If Collamat labels only at 3m/min, change the monitor speed setting to meet the requirements, because it may be set to default FIXED SPEED.
How to fix wrong motor turning direction in Collamat 8600 Label Maker?
If the motor turning direction is wrong on your Collamat Label Maker, you can: * Change the MOTOR DIRECTION setting on the monitor. * Reconnect motor wires according to the Technical Handbook if there is wrong motor connector wiring. * Reconnect motor cable according to the Technical Handbook if there is wrong motor cable wiring.
General| Brand | Collamat |
|---|---|
| Model | 8600 |
| Category | Label Maker |
| Language | English |
