How to fix wrong motor turning direction in Collamat 8600 Label Maker?
If the motor turning direction is wrong on your Collamat Label Maker, you can: * Change the MOTOR DIRECTION setting on the monitor. * Reconnect motor wires according to the Technical Handbook if there is wrong motor connector wiring. * Reconnect motor cable according to the Technical Handbook if there is wrong motor cable wiring.
Why does the mains fuse often blow in Collamat 8600 Label Maker?
If the mains fuse often blows on your Collamat Label Maker, it could be due to: * The mains impedance is too low: Use an extended power cord. * The mains fuse is too weak: Use a slow blow (timed) mains fuse.
What to do if Collamat Label Maker has no action after power on?
If there is no action after powering on the Collamat Label Maker but the motor is under power, consider the following: * Try LABEL JOG in the LABELING MODE menu if there is a missing good scanner signal. * Set the monitor to RUN if it is stopped. * Set the monitor to the appropriate mode if it is set to NONSTOP SLAVE.
Why do labels form bubbles with Collamat Label Maker?
If labels form bubbles when using the Collamat Label Maker, reduce the labeling speed, because it may be too fast.
What to do if motor driver LEDs are on but motor is dead in Collamat 8600?
If the motor is dead, the display is illuminated, LED1 is on, and the motor driver may not be working on your Collamat Label Maker, check the motor driver LEDs: * If LED2 is on, there is a short of the motor phases: check the wires between the motor driver and the mains filter board and the motor connector. * If LED3 is on, there is too high temperature: check the cause. * If LED4 is on, there is overvoltage: check the voltage selector and the transformer wiring. * If LED5 is on, there is undervoltage: check the voltage selector and the transformer wiring.
Why does Collamat 8600 Label Maker motor make noise and shake?
If the motor makes noise and shakes and does not turn correctly on your Collamat Label Maker, consider the following: * Replace the motor driver, as it may be faulty. * Connect motor wires according to the Technical Handbook if there is a missing connection of one motor wire.
Why do labels form wrinkles with Collamat Label Maker?
If labels form wrinkles when using the Collamat Label Maker, consider the following: * Increase the labeling speed if it is too slow. * Realign the labeler if it is misaligned to the product transport.
What to do if motor is dead and display is not illuminated in Collamat 8600 Label Maker?
If the motor is dead and the display is not illuminated on your Collamat Label Maker, check the following: * Ensure the main is connected to the transformer. * Check the main fuse. * Check the internal transformer wiring.
What to do if motor is dead but display is illuminated in Collamat 8600?
If the motor is dead, the display is illuminated, and the motor driver seems to be okay on your Collamat Label Maker, check the following: * Ensure the motor connector is properly plugged in. * Reconnect the wires between the motor driver, the mains filter board, and the motor connector, if they are not okay. * Replace the mains filter board if the filter components are broken. * Rewire the motor wires properly if they are not connected properly inside the motor.
General| Brand | Collamat |
|---|---|
| Model | 8600 |
| Category | Label Maker |
| Language | English |
To Next Page
