Collamat 8600 - Change Program

5.1 Change program
The Change program function is used to branch in an additional menu by calling up further parame-
ters to be changed:
CHANGE PROGRAM
Labelscanner Sens.
Label Length
Label Suppression
Predispensing
Position
Speed
Max. Speed
Good Suppression
Labelling Mode
Profiling
5.2 Label scanner sensitivity
The Label scanner sensitivity function is used to adjust the label scanner sensitivity manually or
automatically. This function is not necessary for mechanical label scanning.
LABEL SCANNER SENS.
Auto adjust
Manual adjust
User level:
programmer/operator
RUN/STOP
Operating mode:
5999.530-01E 14.01.2004 CSWM 4 18