8.5 Error diagnosis
In the service part of the error sequence menu, all errors and warnings will be registered and indica-
ted. This is helpful to trace back the error history of the labeller. Thus, if an error happens frequently,
it can be better identified and eliminated. The error history also helps the technical operator in case
of inquiries. Note the error numbers in indicated order for further inquiries.
The description of the particular error numbers and their error texts, causes and elimination will
follow.
Error #1 Not ready
Cause:
A peripheral appliance (flat printer, hotstamp etc.) has not yet released the signal READY at the
starting time of the labelling.
Solution:
Reducing the cadence. Reducing the time activated by the READY signal. If a G&S flat printer
GS077D is used, reducing the printing time by trimmer P1.
Error #2 TUNIT / Paperend
Cause:
1. The lock in the traction roller or the paper brake is open.
2. The label roll is empty.
Solution:
1. Close lock of traction roller or paper brake.
2. Insert a new label roll.
Error #3 Position too short
Cause:
The position value is too low for the actual labelling speed. The label is sticked in false position on
the goods.
Solution:
Increasing the position value or reducing of labelling speed.
Error #4 Max. Speed
Cause:
The measured goods speed is higher than the entered max. labelling speed. Labelling becomes
faulty.
Solution:
Reducing the goods speed or, if possible, increasing the max. labelling speed.
Error #5 Label stock
Error #6 Rewinder full
Cause:
The label stock of the unwinder is empty or the rewinding disk of the rewinder is full.
Solution:
Replace empty paper roll or remove backing paper roll from rewinder disk.
5999.530-01E 14.01.2004 CSWM 4 46
To Next Page
Loading...
