What to do if FAULT LED indicates motordriver supervision issues on Collamat 3600?
If the FAULT LED indicates motordriver supervision issues on your Collamat Label Maker, it could be due to overheating, a short circuit, undervoltage, or a blown fuse F2. You should investigate and address any overheating, short circuit, or undervoltage issues. Also, check and replace fuse F2 if necessary.
Why is the 12V LED illuminated on my Collamat 3600 Label Maker?
If the 12V LED is illuminated on your Collamat Label Maker, it indicates that the 12V for the sensors are not working correctly. This could be due to fuse F3 or F1 being defective, or a short circuit in the sensor supply. Check and replace F3 or F1. Also, check for any short circuits.
What to do if 5V LED is illuminated on Collamat Label Maker?
If the 5V LED is illuminated on your Collamat Label Maker, it means that the 5V for the logic circuit is not working correctly. This could be due to a blown fuse F3 or F1. You should check and replace F3 or F1.
Why does the RESET LED flash on my Collamat 3600 Label Maker?
If the RESET LED flashes while turning the power on or while running on your Collamat Label Maker, it indicates a Watchdog RESET. You should investigate for a software failure.
General| Supported Label Materials | Paper, PE, PP, PET |
|---|---|
| Printing Technology | Thermal transfer |
| Maximum Label Width | 176 mm |
| Print Speed | Up to 300 mm/second |
| Resolution | 300 dpi |
| Connectivity | Ethernet, USB, RS232 |
| Memory | 8 MB RAM, 8 MB Flash |
| Dimensions | 430 x 270 x 310 mm |
| Weight | Approx. 12 kg |
To Next Page
