Introduction
General informations
This documentation describes the serial communication with the Collamat
®
3600/6600
an a PC or Laptop running under Windows 3.1, Windows 3.11and Windows 95.
Prevention of accidents
While installing and connecting the Collamat
®
6600 take care that the signal cables and
power cables can't become obstacles. The cables must be placed and installed accor-
ding to the national safety requirements. Take care that the signalcables are not placed
beneath power cables.
The mains switch and the controll elements must be easily accessible.
Noise suppression
The dispenser C6600 is shielded according to the CE directives. Only cables which are
certificated by Collamat Stralfors AG may be used for connecting the dispenser to the
peripheral units and the mains power. Additional peripheral units must be connected to
the auxiliary mains terminal of the dispenser. These assemblies must be certificated by
Collamat Stralfors AG.
5999.527-01A 25.11.98 WM Seite 4 / 32
To Next Page
Loading...
