3. Mirage™ cooling line to QCM
The cooling line is connected to
the Mirage™ via an insulated
cooling tube. Slide “push-to-
connect” tting onto the 3/16”
cooling pipe projecting from the
QCM ange. Featuring an
interior detent, cooling tube will
snap securely in place.
15
Chapter 2 Getting Started
Connecting to Eon™
1. BNC Coaxial Cable to Eon™
Slide coaxial connector onto
BNC.
2. Heater Control Cable (DB-15
Connector) to Eon™
Plug DB-15 connector into
the Eon™ 15-pin male heater
port.
WARNING DO NOT allow operating temperature to exceed 500°C.
Equipment damage will likely result.
To Next Page
Loading...