16
Chapter 2 Getting Started
Hardware and electronics
2. Compressed Air Input to
Mirage™
Connect the Mirage™ to a
ltered and oil-free compressed
air source. (Air ttings may vary
by country but require a 1/4 NPT
female connection.
3. Eon™ Supplies Power to
Mirage™ through Power
Module
The 3-pin solenoid module
provides power to Mirage™.
Tighten integrated screw after
mating to Mirage™. The DB-9
connector on other end attaches
to male I/O port on Eon™.
1. Cold Air Output from Mirage™
to Tempe™
Slide the 3/16” tube onto the
“push- to-connect” tting on rear
of the Mirage™ cooling system.
The Mirage™ provides a
maximum output of 28˚C (50˚F)
below the compressed air
source.
To Next Page
Loading...