Colnatec Eon - Page 26

Heater Control
4
26
Chapter 4 Heater Control
Heater Control Screen
Click the Heater Control button in the Screen Selection tool bar to access the Heater
Control screen. With this screen the user will be able to create new heating cycle, edit or
delete existing heating cycles, as well as adjust the heater settings.
Heater Thermostat
Heating Cycle List
Create new, or
delete existing
heater cycle
Heater Settings List
Activate heating cycle, heater, or
heater shutoff
Adding heater constants. Before the heater can be engaged, the heater constants
specic to each sensor must be entered into the heater constant elds on the Settings
screen. Click the Settings button in the Screen Selection tool bar. Under the Heater tab
on the Settings screen enter the heater constant data into the Heater Constant A and B
elds. The heater constants for the sensor head were included with the paperwork that
accompanied your sensor.
Temperature & Power Indicators
Screen Selection Tool Bar
Vertical Tool bar