41
Chapter 6 Manual Mode
Exiting Manual Mode
Click the Abort button to exit Manual Mode and return to the standard
operating environment.
Note: Pressing the Abort button returns both sources to 0 power.
IMPORTANT When the user manually adjusts the value of the source
power output, the source will no longer be controlled by the PID,
regardless of the current process. If a source is adjusted during a
deposition, the Eon™ will no longer control the source controlling the
PID or the predeposition processes, as the user has taken full control
over the source. This also applies to the heater. Adjusting source
power to the heater disables the feature in Eon™ that automatically
regulates the temperature of the sensor body, and will also halt the
heater from continuing its initialization process if it is currently in one.
To Next Page
Loading...