Colnatec Eon - Page 42

Vertical Tool Bar
7
42
Chapter 7 Vertical Tool Bar
Using the Vertical Tool Bar
Like the Screen Selection tool bar, the vertical tool bar is always available. Use the
vertical tool bar to start a deposition, abort a process, record a log, zero the sensors,
activate the relays, enter Manual Mode, or exit Eon™ software.
Starting a Deposition
A deposition process can be started from any screen. The process selected in the
Process List on the Program Control screen or through the Remote Process Control
panel is the process that will run.
Press the Start button to begin the process. When the process is complete, a
Process Complete notication will appear.
Tip: To create a new process, navigate to the Program screen and select New under the
Process List.