Colnatec Eon - Page 65

Vertical tool bar
Starting a deposition
1. A deposition can be started from any screen.
2. Ensure that the desired process to run is selected in the Remote Process
Control panel on the Green Status bar.
3. To start the process, press the Start button on the vertical tool bar.
4. Wait for the Process Complete notication to appear.
Abort button to end a process or exit Manual Mode
1. From any screen, press the Abort button to end a process or exit Manual Mode.
Note: Abort does NOT shut off the heater!
Resuming an Aborted Process
If a process has been aborted before it has been completed, and a new process
has not been selected, the original process can be resumed.
1. To resume a process, press the Start button from any screen.
2. When prompted to Resume or Restart, press Resume.
Logging the status of the Eon™
1. Press the Log button on the vertical tool bar.
Note: Eon™ status can be logged to a monitor log from any screen. Pressing the Log
button saves a monitor log to the monitor log save folder (MyDocuments/eon_logs/
monitoring”).
When a process is initiated, Eon software will automatically begin recording the
real-time status of the process to the process log folder (MyDocuments/eon_logs/
processes). If a process is started while an Eon™ monitor log recording is in
process, Eon™ will automatically stop recording to the monitor log and begin
recording to the process log.
Zeroing Both Sensors Manually
1. Press the Zero All Thickness button on the Screen Selection tool bar.
Activating Relays Manually
1. The relays can be activated from any screen.
2. On the Screen Selection tool bar, toggle the Relay # button to activate the
relays.
65
Appendix B Quick Commands