Colnatec Eon - Page 66

66
Appendix B Quick Commands
Settings
Note: All settings are automatically updated and saved as soon as they are changed.
Adjusting Eon™ period readings
1. Press the Settings button on the Screen Selection tool bar.
2. Select General tab.
3. Click and drag the marker on the Period control to adjust the period time in
increments of 100ms.
Changing Thickness Units [KÅ, Å]
1. Press the Settings button on Screen Selection tool bar.
2. Select General tab.
3. Select the desired thickness measurement units.
Entering the Heater Constants
1. Press the Settings button on the Screen Selection tool bar.
2. Select General tab.
3. Enter the value of Heater Constant A and Heater Constant B.
4. Update the values by unselecting the box or pressing enter.
Note: The heater constants ensure that the heater functions correctly. Each heater has
its own unique values. These values can be found in the documentation that ships
with the product. If these values are unavailable, please contact Colnatec Support
at support@colnatec.com or call 480-634-1449.
Disable/Enable Sensor Failure Alerts
1. Press the Settings button on the Screen Selection tool bar.
2. Select Alerts tab.
3. Check or uncheck the checkmark box of the corresponding sensor to enable
or disable failure alerts.
• Checked: Shows sensor failure alerts
• Unchecked: Hides sensor failure alerts
Append a Log Name to Log les
1. Press the Settings button on the Screen Selection tool bar.
2. Select Logs tab.
3. Enter text to append a log lename
Note: Using the characters */>”:| will cause the lename to be invalid and can prevent
logs from being recorded.