Colorful B365M-HD PRO V21 - Page 55

 State After G3
Set up power-on automatic boot-up.Options: Always On （ Automatic
boot-up state）,Always Off（Shutdown state）
 Wake on LAN Enable
Set up network wake-up. Options: Disabled, Enabled.
Super IO Configuration (IO setting)
Click on the "Serial Port Configuration" option, the following two sub options
will appear.

Serial Port
Start and close the serial port controller. Options: OFF, ON.

Change Settings (change)
This option is used to change the serial port address.
Hardware Monitor (hardware monitoring)

CPU Fan Smart Mode
Set the CPU FAN mode.Options:Full on Mode,Automatic Mode,Manual
Mode.

SYS Fan Smart Mode
Set the SYS FAN mode.Options:Full on Mode,Automatic Mode,Manual Mode.

CPU Temperature
Display the temperature of the current "CPU".

SYS Temperature
Display the temperature of the current "SYSTEM".

CFAN Speed
Show the speed of current CPU fan.

SFAN Speed
Show the speed of current system fan.

CPU/DIMM/+12V/5VCC Voltage
The current CPU voltage / memory voltage / +12V/5VCC voltage is
displayed.
49
ＢＩＯＳ Ｓｅｔｔｉｎｇ