Com G-95 - Page 20

16
Menu
#
Menu
Name
Description
Secondary
Menu
Notes
MIC-V
Display Mic Audio level on bottom
display bar
44 MEM-CH Program Channel
000 > 199
Indicates channel number to be
stored to memory (Disabled)
45 DEL-CH Delete Channel
000 > 199
Indicates channel number to be
deleted from memory
46 SFT-D Frequency shift direction
Off
No offset (simplex)
+
Plus frequency shift
-
Minus frequency shift
47 OFFSET
Frequency shift offset
amount
00.00 >
69.99
frequency shift in MHz
48
ANI
ANI ID Code
Can only be set with software
49
ANI-L
ANI Length
3, 4, 5
Length of ANI ID code
50 REP-S Repeater Activation Tone
1000Hz,
1450Hz,
1750Hz,
2100Hz
Audible tone for repeater activation
51 REP-M Repeater forwarding Mode
Off
Function Off
CARRI
Forward after receiving carrier
CTDCS
Forward after receiving correct
CTDCS
TONE
Forward after receiving correct
mono audio (Menu 42)
DTMF
Forward after receiving assigned
DTMF code (ANI)
52 TMR-MR
TMR - Return time delay to
primary channel; this is the
time delay before
returning indicator to the
primary channel for TMR
(Menu # 0).
Off
Function Off - Transmits always on
Primary channel
1 > 50
seconds
This is the delay time before
returning to the primary channel
after secondary signal is clear
53 STE
Squelch tail elimination
requires both radios to
have function "ON"
Off
Function Off
On
Eliminates squelch tail at end of
transmission
54 RP-STE
Repeater Squelch Tail
Elimination Requires a
repeater using this
function
Off Function Off
1 > 10 Delay time (sec)
55 RPT-DL Repeater squelch tail delay
Off
Function Off
1 > 10
Delay time (sec)
56 DTMF-G DTMF Gain / Audio level 0 > 60
0 = Lowest Audio Gain;
60 = Highest Gain
57 PONKEY
Turn on radio by
connected power supply
Off
After energizing, radio powers on
automatically