Com G-95 - Specifications; Technical Specifications; Receiver Specifications; Transmit Specifications

20
Specifications
Technical Specifications
Description
Spec
Frequency Range (MHz)
VHF: 136-174 MHz Rx only
UHF: 400-480 MHz Rx only
GMRS (Channels 015-030) Tx/Rx
GMRS (Channels 01-014) Rx Only
Memory Channels
200
Frequency Stability
±2.5ppm
Frequency Step (kHz
2.5k/5.0k/6.25k/10.0k/12.5k/25.0k
Squelch Setup
CARRIER / CTCSS / DCS / 5Tone / 2 Tone / DTMF
Antenna Impedance
50 Ohm
Operating Temperature
-20º C (-4º F) to 60º C (140º F)
Supply voltage
13.8V DC±15%
Dimension
5.7(W) x 1.85 (H) x 7.5 (D)in
Weight
998 g (2.2 lb)
Receiver Specifications
Description
Broadband
Narrow Band
Sensitivity
≤ 0.25 µV
≤ 0.35 µV
Channel Choice
≥ 70 dB
≥ 60 dB
Intermodulation
≥ 65 dB
≥ 60 dB
Spurious Rejection
≥ 70 dB
≥ 70 dB
Audio response
+1~-3dB (0.3-3KHz)
+1~-3dB (0.3-2.55KHz)
Signal to noise ratio
≥ 45 dB
≥ 40 dB
Audio distortion
≤ 5%
Audio output power
≥ 2W ± 10%
Transmit Specifications
Description
Broadband
Narrow Band
Output Power
20W UHF (VHF is disabled)
Modulation Mode
16KΦF3E
11KΦF3E
Channel Power
≥ 70 dB
≥ 60 dB
Signal to Noise Ratio
≥ 40 dB
≥ 36 dB
Parasitic Harmonic
≥ 60 dB
≥ 60 dB
Audio Response
+1~-3dB (0.3-3KHz)
+1~-3dB (0.3-2.55KHz)
Audio Distortion
≤ 5%