26
Getting started
Remote control
Two Micro type batteries are required for the remote control:
LR 03/AAA/1.5 V
Open the battery compartment.
Insert two batteries into the battery compartment paying
attention to the indicated polarities and push the cover of the
battery compartment carefully until the cover is locked.
Replace discharging batteries immediately.
Always replace both batteries simultaneously and use batteries
of the same type.
If any battery has leaked, wear protective gloves and clean the
battery compartment with a dry cloth.
Caution!
Batteries may contain toxic agents that are
hazardous to health and environment.
Therefore, dispose of the batteries immediately
according to the prevailing statutory
regulations. Never throw the batteries into
normal household waste.
The remote control transmits infrared signals to the receiver.
Please refer to the overview of the remote control for the
functioning of the keys.
Point the remote control towards the front side of the receiver
and slightly press the corresponding key once.
To Next Page
Loading...