COMBA COMFLEX Series - Page 56

USER MANUAL FOR COMFLEX-6Q00 5W
ENU STATUS: 1-0-1 Copyright - refer to title page Page 54
 Firmware
There are three functions on the [Firmware] bar: [Monitoring Upgrade], [Swap] and [Module Upgrade].
[Monitoring Upgrade] is used to upgrade software. [Swap] is to replace current firmware version to the
previous one. [Module Upgrade] is used to upgrade module software.
Figure 61: Function - Firmware
 Alarm Log
Figure 62: Function – Alarm Log
M
aster unit
software upgrade
Master Unit
software swap
S
laver Unit
software upgrade