Comdial DX-80 - Page 134

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-84
Program Day Mode Answering Positions (02-740~755-13-01-01):
• Input 02-ccc-13-01-01 (“ccc” is the CO Line directory number), then press [save]. The Day mode Member 1
Answering Position displays.
• To change this member press [
chg
chgchg
chg].
Or…
• To advance to the nest member press [next
nextnext
next].
• Press [chg
chgchg
chg] to change the stored member (ringing/answering position).
• Input the directory number for the ringing position (extension, 101-156; UCD, 410-433; or Virtual number,
700-730.)
• Press [
save
savesave
save] to store this data.
• Continue making other changes or exit programming.
Program Eve Mode Answering Position (02-740~755-13-02):
• Input 02-ccc-13-02 (“ccc” is the CO Line directory number), then press [save
savesave
save]. The Eve mode Answering
Position displays.
• Press [
chg
chgchg
chg] to change the stored answering position (ringing/answering position).
• Input the directory number for the ringing position (extension, 101-156; UCD, 410-433; or Virtual number,
700-730.)
• Press [save
savesave
save] to store this data.
• Continue making other changes or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press
«.
• Use ¢£¤¥ to highlight “CO Line.” Then press «.
• Use
¢£¤¥ to highlight “Answering Position.” Then press «.
• Use ¢£¤¥ to highlight the Day Member or Eve answering position. Then press «.
• Input the directory number for the ringing position (extension, 101-156; UCD, 410-433; or Virtual number,
700-730.)
• Press « to store this data.
• Continue making other programming changes as required.
• When you have completed all changes, press the
° (escape) key to exit this database programming
screen. You will see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.